OSPF6 Required Information

Before starting, take the time to gather all of the information required to form an OSPF6 adjacency to a neighbor. This list is similar to that of OSPF. At a minimum, FRR will need to know these items:

Local Router ID:

Typically the highest numbered local address on the firewall. This is also frequently set as the internal or LAN side IP address of a router. It does not matter what this ID is, so long as it is given in IPv4 address notation and does not conflict with any neighbors.

OSPF6 Area:

A designation for the set of networks to which this router belongs. Can be any number capable of being expressed in dotted quad notation (IPv4 address) or as a 32-bit unsigned integer.

OSPF6 Active Interfaces:

The interfaces on this router upon which the OSPF6 daemon will advertise itself and monitor for neighbors. These interfaces are connected to network segments with other routers. They may be connected to local networks or remote point-to-point links. These interfaces only require an IPv6 link local address.

OSPF6 Active Interface Cost Values:

OSPF6 calculates the most efficient way to route between networks based on the total cost of a path from source to destination. Less desirable links (e.g. wireless) can be given a higher cost so that paths over faster networks will be used by traffic unless the preferred path is unavailable. For single connections to other networks, this value is not necessary and may be omitted or set to a simple default such as 5 or 10.

OSPF6 Passive Interfaces:

These interfaces contain networks which FRR will advertise as reachable through this router, but do not contain other routers.

The example in this section uses the following values:

Example OSPF Configuration

Item	Value
Local Router ID	10.2.0.1
OSPF6 Area	0.0.0.0
Active Interfaces (Cost)	OPT1 (10)
Passive Interfaces	LAN