CentOS 7.1

  1. Download CentOS-7-x86_64-Minimal-1503-01.iso. Go to the CentOS Website and download the Minimal ISO. Click one of the mirror links to download the file.

  2. Write the image directly to a USB memstick.

    See also

    Writing Flash Drives

    Writing an OS installation image to flash media

  3. Connect to the console port using a mini-USB cable attached to another system.

    See also

    Connecting to Console Port

    Connecting to the console port. Cable is required.

  4. Place the memstick in one of the USB ports and boot the system.

  5. After a minute, a screen will display a menu that offers the choice to Install CentOS 7 or Test this media & install CentOS 7. Move the cursor to either of the above lines and press the Tab key.

    ../_images/centos-rcc-ve-1.png

  6. The command line used to start the kernel will be displayed. The current installation options will be displayed, such as vmlinuz initrd=initrd.img inst.stage2=hd:LABEL=CentOSx207x20x86_64 quiet. Move the cursor to the end of the line, press Space and then type console=ttyS1,115200n8. Press the Enter key.

    ../_images/centos-rcc-ve-2.png

  7. The kernel will then start. It can take a few seconds for output to be displayed on the console, but after some time the installer will appear.

  8. A menu labeled Installation will be displayed which has nine choices. All with [!] must be resolved before you can continue with the installation. Configuring Timezone settings, Installation Destination, and Root Password will correct them all.

    ../_images/centos-rcc-ve-3.jpg

  9. Press b from the main menu to begin the installation, then press the Enter key. Messages are displayed indicating the progress of the installation as it works. Once all installation steps have completed, a message is displayed that says “Installation complete. Press return to quit”. At that point, press Enter and the system will reboot.

    Note

    The system will appear to hang on Performing post-installation setup tasks, but it will continue after about 1 minute.

  10. When you see the message that the system is restarting, remove the USB drive from the USB port while the system reboots. CentOS 7 will start up automatically from the hard drive. If the USB drive remains attached, the system will boot into the installer again.

  11. After the system finishes rebooting, you can log in with the user root and the password that you chose. Refer to the I/O Ports section if you need the physical port assignments.