Reinstalling pfSense Plus Software¶
Please open a TAC ticket to request access to the Plus firmware by selecting Firmware Access as the General Problem and then select Netgate XG-1540 1U for the platform. Make sure to include the serial number in the ticket to expedite access.
Once the ticket is processed, the latest stable version of the firmware will be attached to the ticket, with a name such as:
pfSense-plus-memstick-23.09-RELEASE-amd64.img.gz
Note
pfSense® Plus is preinstalled on Netgate appliances, which is optimally tuned for Netgate hardware and contains features that cannot be found elsewhere, such as ZFS Boot Environments, OpenVPN DCO, and the AWS VPC Wizard.
Write the image to a USB memstick. Locating the image and writing it to a USB memstick is covered in detail under Writing Flash Drives.
Connect to the console port of the Netgate device.
Insert the memstick into an open USB port and boot the device.
After a minute the pfSense® Plus loader menu will be displayed with a 3 second timer. Either allow the menu to timeout or press
1
(the default) to continue.Console options are presented for serial console installation. The default option is
vt100
, which should work for most. Choose the correct console output most compatible with the serial client.Please choose the appropriate terminal type for your system. Common console types are: ansi Standard ANSI terminal vt100 VT100 or compatible terminal xterm xterm terminal emulator (or compatible) cons25w cons25w terminal
The installer will automatically launch and several options will be presented. On Netgate appliances, choosing
Enter
for the default options will complete the installation process.Note
Options such as the type of disk partition can be modified through this installation if required.
See also
For more information on the available choices during this process, see the Installation Walkthrough.
Once the installer is finished, choose
No
and pressEnter
to skip going to a shell.The installer will then prompt to Reboot. Select Reboot and press
Enter
. The device will shutdown and reboot.Dec 21 22:41:37 Waiting (max 60 seconds) for system process `vnlru` to stop... done Waiting (max 60 seconds) for system process `bufdaemon` to stop... done Waiting (max 60 seconds) for system process `syncer` to stop... Syncing disks, vnodes remaining... 0 0 done All buffers synced. Uptime: 5m43s umass0: detached umass1: detached uhub1: detached
Remove the USB drive from the USB port.
Important
If the USB drive remains attached, the system will boot into the installer again because by default the system firmware is configured so that a device plugged into the USB port will be booted with a higher priority.
See also
For information on restoring from a previously saved configuration, go to Backup and Restore.