Factory Reset Procedure¶
This procedure performs a factory reset using the hardware button on the Netgate 6100.
Shut down or remove power from the device.
Power on the device.
Wait for the circle LED to change from orange to blue.
Press and hold the reset button (top) for 5 seconds.
This is the top (recessed) button and may require a pen, paperclip, or similar tool to press.
This “short press” of the button initiates the reset procedure.
After the system mounts the drive it recognises that the button had a short press and then it prompts to confirm the reset by turning all of the LEDs solid red.
Wait for the LEDs all change to solid red.
Hold the reset button until all three LEDs start flashing red
This will take approximately 13 seconds
The system then resets the configuration and reboots.
Wait for the system to complete the reset and finish the boot process.
At the end of the boot process the LEDs will return to the ready state, with the diamond light slowly flashing blue.
When the device boots again it will be at its factory default settings and
accessible from the LAN at
If this procedure fails, connect to the console and perform a factory reset there.