Routed IPsec (VTI)¶
Route-based IPsec is an alternative method of managing IPsec traffic. It uses
if_ipsec(4) from FreeBSD 11.1+ for Virtual Tunnel Interfaces (VTI) and
traffic is directed using the operating system routing table. It does not rely
on strict kernel security association matching like policy-based (Tunneled)
A routed IPsec tunnel creates an
ipsecXXXX interface at the operating system
level and this interface has its own IP address. The
must be assigned so it can be used for purposes such as static or dynamic
routing, daemon binding, traffic monitoring, and so on.
Once assigned, the IPsec interface also gains an automatic gateway which provides policy routing and gateway group capabilities.
Routed IPsec is not replacing traditional tunneled IPsec, both may be used. The choice is up to the user when creating an IPsec Phase 2 entry.
Routed IPsec is available on firewalls running pfSense® software version 2.4.4-RELEASE or later.
First, pick a transit network. This is similar to choosing a tunnel network for
an OpenVPN instance. Typically this is a /30 network in an unused subnet. This
Create an IPsec Phase 1 entry as usual.
Create a Phase 2 entry under this Phase 1, set with…
Set Mode to Routed (VTI)
Set Local Network to Network
10.6.106.1/30for the Local Network Address
10.6.106.2for the Remote Network Address
Add a useful Description
Set the Proposal settings as needed
Click Save, then click Apply Changes
IPsec Interface Assignment¶
Navigate to Interfaces > Assignments
Pick the new
ipsecXinterface from the Available Network Ports list
Click + Add
Note the new interface name, e.g. OPT1
Navigate to Interfaces > [New Interface Name]
Give the interface a more suitable name using the Description field (e.g. VTI_FOO)
Leave the IPv4 Configuration Type and IPv6 Configuration Type set to None
Click Save, then click Apply Changes
A gateway is created automatically and can be used for static routing, policy routing, and so on.
At this point the interface is available for use like any other interface. It can be used for packet captures, traffic graphs, binding daemons, routing protocols, and other tasks never before possible with IPsec on pfSense software!
Until routing is configured, no traffic will attempt to cross the IPsec tunnel except for gateway monitoring probes, if they are enabled.
To setup static routes, navigate to System > Routing, Static Routes tab. Add a new route there using the assigned IPsec interface gateway.
To policy route traffic across a routed IPsec tunnel, use the assigned IPsec interface gateway in firewall rules as usual for policy routing.
The assigned IPsec interface can be used in dynamic routing daemons such as FRR, Quagga, and OpenBGPD. BGP and OSPF can both operate across routed IPsec interfaces.
Routed IPsec Firewall Rules¶
Routed IPsec traffic appears to the OS on both the specific IPsec interface and the enc0 interface, which is governed by the rules on the IPsec tab. Though a tab appears for the assigned interface, traffic must be passed on the IPsec tab.
Routed IPsec works best when both sides support routed IPsec. It can still work when only one side supports routed IPsec, but most of its benefits are lost.
Rather than managing IPsec Phase 2 entries, routes must be managed instead. Since this can be automated with dynamic routing protocols this is not a large concern.
Firewall rule processing can be confusing, as mentioned in Routed IPsec Firewall Rules. This is still undergoing testing, but likely means that reply-to will not function. There are also known issues with NAT, notably that NAT to the interface address works but 1:1 NAT or NAT to an alternate address does not work.