This is the documentation for the 22.02 version. Looking for the documentation of the latest version? Have a look here.
MACIP ACLs and layer 3 ACLs (Standard ACLs) work similarly, but MACIP ACLs match traffic at layer 2 using MAC addresses.
Since MACIP ACLs work with layer 2 information, they can only effectively function on interfaces which support operating at layer 2, such as Ethernet. Additionally, MACIP ACLs can only match layer 2 interface packets from neighboring hosts on directly connected networks.
The MAC address of a remote host that reaches TNSR via routing though another gateway cannot be determined, thus cannot be matched by a MACIP ACL.
For example, traffic arriving at TNSR from the Internet via Ethernet will typically have a source MAC address of the default gateway or routing peer, and not the actual source of the traffic.
MACIP ACLs may only be applied in the input direction, and only match source addresses.
- description <text>
Text describing the purpose of this ACL.
- action <name>
Determines how the rule governs packets that match.
Drops a packet which matches this rule.
Passes a single packet matching the rule.
- ip-version (ipv4|ipv6)
Controls whether IPv4 or IPv6 packets will be matched by the rule. This is required when an
addressis present for the rule, and governs validation of the
addressvalue when applicable.
- address <ip-prefix>
Match the source IPv4 or IPv6 address of a packet.
- mac address <mac-address>
Optionally specifies a MAC address to block, in six groups of two colon-separated hexadecimal values, such as
00:11:22:33:44:55. When unset, the default value is
00:00:00:00:00:00and uses the same value for a mask, which will match any MAC address.
- mac mask <mac-mask>
Optionally specifies a mask which defines portions of a MAC address to match, similar to an IP Prefix value. Given in six groups of two colon-separated hexadecimal values, such as
ff:ff:ff:00:00:00, which matches the first half of a given MAC address. A mask of
ff:ff:ff:ff:ff:ffmatches an entire MAC address exactly. A mask of
00:00:00:00:00:00matches any MAC address, and is the default behavior when no mask is set.
MACIP ACL Example¶
tnsr(config)# macip blockamac tnsr(config-macip)# rule 10 tnsr(config-macip-rule)# action deny tnsr(config-macip-rule)# mac address 00:11:22:33:44:55 tnsr(config-macip-rule)# mac mask ff:ff:ff:ff:ff:ff tnsr(config-macip-rule)# exit tnsr(config-macip)# exit tnsr(config)# int GigabitEthernet0/14/2 tnsr(config-interface)# access-list macip blockamac tnsr(config-interface)# exit tnsr(config)#