Tip

This is the documentation for the v21.03 version. Looking for the documentation of the latest version? Have a look here.

Locate Interfaces

The next step is to decide the purpose for which TNSR will use each interface.

First, look at the list of interfaces:

tnsr# show interface
Interface: GigabitEthernet0/14/1
[...]
Interface: GigabitEthernet0/14/2
[...]
Interface: local0
[...]

In the above shortened output, there are two viable interfaces, GigabitEthernet0/14/1 and GigabitEthernet0/14/2. These can be used for any purpose, so map them as needed for the design of the network for which TNSR will be routing.

The example configuration for this network is:

Example Configuration

Interface

Function

IP Address

Gateway

GigabitEthernet0/14/1

WAN

203.0.113.2/24
2001:db8:0:2::2/64
203.0.113.1
2001:db8:0:2::1

GigabitEthernet0/14/2

LAN

10.2.0.1/24
2001:db8:1::1/64

n/a

Connect the interfaces on the router hardware to the appropriate networks at layer 1 and layer 2, for example by plugging the WAN into an Internet circuit and the LAN into a local switch. If TNSR is plugged into a managed switch, ensure that its ports are configured for the appropriate VLANs.

Tip

These interface names can be set to custom values. See Customizing Interface Names for details.