pfSense® Community Version

  1. Retrieve pfSense-CE-memstick-ADI-2.4.4-RELEASE-p1-amd64.img.gz from the pfSense® Download Page. On that page, Select Netgate ADI from the Architecture drop-down for the proper image.

  2. Write the downloaded image to a USB memstick.

    See also

    Writing Flash Drives

    Writing an OS installation image to flash media

  3. Connect to the console port of the Netgate device using a mini-USB cable attached to another system.

    See also

    Connecting to Console Port

    Connecting to the console port. Cable is required.

  4. Insert the memstick in the top USB port and boot the system.

  5. After a minute the pfSense loader menu will be displayed that contains options to Boot Multi User, Boot Single User, Escape to loader prompt, Reboot, select a non-default kernel or configure boot options. Either allow the menu to timeout and boot on its own, or press 1 to boot normally. The ADI-specific image of pfSense already has the console port options set correctly.

  6. Console options are presented for serial console installation. The default option is vt100, which should work for most. Choose the correct console output for your system.

    Please choose the appropriate terminal type for your system.
    Common console types are:
       ansi     Standard ANSI terminal
       vt100    VT100 or compatible terminal
       xterm    xterm terminal emulator (or compatible)
       cons25w  cons25w terminal
  7. The installer will automatically launch and several options will be presented. Press Enter for the default options to complete the installation process.


    Options such as the type of disk partition can be modified through this installation. For more details on available choices through this part of the process, see The pfSense Book Installing and Upgrading section.

  8. The final step of the installation will be a prompt to Reboot the system. Select Reboot and press Enter. The system will shut down and reboot.

    Dec 21 22:41:37 Waiting (max 60 seconds) for system process `vnlru` to stop... d
    Waiting (max 60 seconds) for system process `bufdaemon` to stop... done
    Waiting (max 60 seconds) for system process `syncer` to stop...
    Syncing disks, vnodes remaining... 0 0 done
    All buffers synced.
    Uptime: 5m43s
    umass0: detached
    umass1: detached
    uhub1: detached
  9. Remove the USB drive from the USB port. pfSense will restart automatically. If the USB drive remains attached, the system will boot into the installer again because by default the system firmware is configured so that a device plugged into the USB port will be booted with a higher priority.