Gateways are the key to routing; They are systems through which other networks
can be reached. The kind of gateway most people are familiar with is a default
gateway, which is the router through which a system will connect to the
Internet or any other networks it doesn’t have a more specific route to reach.
Gateways are also used for static routing, where other networks must be reached
via specific local routers. On most normal networks, gateways always reside in
the same subnet as one of the interfaces on a system. For example, if a firewall
has an IP address of
192.168.22.5/24, then a gateway to another network
would have to be somewhere inside of
192.168.22.x if the other network is
reachable through that interface. One notable exception to this is point-to-
point interfaces like those used in PPP-based protocols, which often have
gateway IP addresses in another subnet because they are not used in the same
Gateway Address Families (IPv4 and IPv6)¶
When working with routing and gateways, the functionality and procedures are the same for both IPv4 and IPv6 addresses, however all of the addresses for a given route must involve addresses of the same family. For example, an IPv6 network must be routed using an IPv6 gateway/router. A route cannot be created for an IPv6 network using an IPv4 gateway address. When working with gateway groups, the same restriction applies; All gateways in a gateway group must be of the same address family.
Before a gateway can be utilized for any purpose, it must be added to the firewall configuration.
If a gateway will be used for a WAN-type interface, it can be added on the configuration page for that interface (See Interface Configuration Basics), or it may be added first manually and then selected from the drop-down list on the interface configuration.
Dynamic interface types such as DHCP and PPPoE receive an automatic gateway that is noted as Dynamic in the gateway list. The parameters for such gateways can be adjusted the same as the parameters for a static gateway, but a dynamic gateway may not be deleted.
To add or manage gateways:
Navigate to System > Routing
Click the Gateways tab
Click Add at the top or bottom of the list to create a new gateway
Click next to an entry to edit an existing gateway
Click next to an entry to delete a gateway
Click to disable an active gateway
Click to enable a disabled gateway
The individual options for gateways are discussed in detail in the next section.