Tip
This is the documentation for the 22.06 version. Looking for the documentation of the latest version? Have a look here.
RIP Interface ConfigurationΒΆ
In basic configurations, RIP will automatically determine which interfaces to use. However, the interface behavior can be tuned when necessary.
To configure settings for RIP interfaces, start in config-frr-rip
mode and
use the interface <if-name>
command to enter config-rip-if
mode.
tnsr(config)# route dynamic rip
tnsr(config-frr-rip)# interface <if-name>
tnsr(config-rip-if)#
config-rip-if
mode contains the following commands:
- authentication mode <mode> [auth-length <type>]:
Configures RIPv2 authentication for this interface. When authentication is enabled, TNSR will ignore updates from unauthenticated peers, including RIPv1 peers.
Note
Updates from unauthenticated peers are ignored, but requests for routes from unauthenticated peers are still honored.
- mode <mode>:
Selects the authentication mode.
- md5:
MD5-based HMAC authentication, which is more secure than plain text. Keys for MD5 authentication are configured with the
key-chain
command inconfig-rip
mode (RIP Keychain Configuration).- text:
Insecure plain text password authentication. The password is set with the
authentication string
command in this mode.
- auth-length <type>:
Configures the expected length of the authentication data.
- rfc:
RFC-compatible data length (
16
bytes).- old-ripd:
Obsolete
ripd
length (20
bytes), compatible only with olderripd
implementations.
- authentication key-chain <name>:
The name of a key-chain to use with MD5 authentication (RIP Keychain Configuration).
- authentication string <auth-string>:
The string used for plain text authentication. Must be less than 16 characters.
- receive version (1|2|both):
Configures the RIP versions allowed to be received by TNSR on this interface.
- send version (1|2|both):
Configures the RIP versions TNSR will transmit on this interface.
- split-horizon [poisoned-reverse]:
Prevents a route from being advertised back to the interface through which it was received. This technique helps to prevent routing loops.
- poisoned-reverse:
Instead of preventing such routes from being advertised, this option causes RIP to actively advertise the networks as unreachable by setting the metric to
16
. This is more proactive for preventing routing loops, but the primary drawback is that this does not scale well, due to the size increase of advertisements.
- v2-broadcast:
When set, TNSR will transmit RIPv2 updates using broadcast on this interface instead of using multicast.