Tip
This is the documentation for the 22.06 version. Looking for the documentation of the latest version? Have a look here.
OSPF6 Debugging InformationΒΆ
The following debugging commands are available in config-frr-ospf6
mode.
Messages will be logged in accordance with the settings in Logging.
- debug abr
Enables debugging for Area Border Routers.
- debug asbr
Enables debugging for Autonomous System Boundary Routers.
- debug flooding
Enables debugging for Link State Advertisement flooding.
- debug interface
Enables debugging for OSPF6 interfaces.
- debug border-routers (area <area-id>|router <router-id>)
Enables debugging for specific border routers, either by area or router ID.
- debug lsa <lsa-type> <event-type>
Enables LSA message debugging.
- LSA Type
Specifies a type of LSA message to debug, which must be one of the following:
as-external
,inter-prefix
,inter-router
,intra-prefix
,link
,network
,router
,unknown
. These message types are described further in Link State Advertisement Message Types.- Event Type
Specifies when to log debug information for the specified type of LSA message.
- examine
Enables debugging when examining LSA messages.
- flooding
Enables debugging when flooding LSA messages.
- originate
Enables debugging when originating LSA messages.
- debug message (dd|hello|ls-acknowledgment|ls-request|ls-update|unknown) (recv|send)
Enables packet-level debugging of OSPF6 messages.
- dd
Debug database description packets.
- hello
Debug OSPF6 hello packets.
- ls-acknowledgment
Debug LSA acknowledgment packets.
- ls-request
Debug LSA request packets.
- ls-update
Debug LSA update packets.
- unknown
Debug OSPF6 messages of unknown types.
Message debugging entries are limited to a single direction:
- send
Debug messages sent by this router.
- recv
Debug messages received by this router.
- debug neighbor event
Enable debugging information for OSPF6 neighbor events.
- debug neighbor state
Enable debugging information for OSPF6 neighbor state changes.
- debug route [(inter-area|intra-area|table)]
Enables debugging for OSPF6 route calculations.
- debug route memory
Enables debugging for OSPF6 route table memory usage.
- debug spf (database|process|time)
Debug SPF calculations
- database
Enable debugging for LSA message counts during SPF calculation
- process
Enable detailed debugging of the SPF calculation process.
- time
Enable debugging for SPF calculation timing.
- debug zebra [(recv|send)]
Enables OSPF6-specific debugging for dynamic routing manager daemon messages, in the send or receive direction, or both when the direction is omitted.