This is the documentation for the 20.08 version. Looking for the documentation of the latest version? Have a look here.
Step 5: Corporate VPN with IPsec Tunnel¶
An IPsec IKEv2 VPN tunnel is configured between the the remote office and the VPN head end at the corporate office.
IPsec Deployment Parameters¶
The IPsec tunnel is built with the following parameters:
IP address of each tunnel endpoint, both the remote office and VPN head end.
Local and Remote Identity and Pre-Shared Key (PSK).
Compatible Phase 1 Proposal: AES128, SHA1, DH14.
Compatible Phase 2 Proposal: AES128GCM16, DH14.
IP address assigned to the tunnel interface, typically a /30 subnet.
IP route to direct corporate traffic over IPsec tunnel via next-hop IP.
The parameters for this deployment were captured at IPsec VPN Tunnel Parameters.
In this example, the Remote Office TNSR is behind NAT on the ISP cable mode, and using a Private IP address.
TNSR Outside IP: 192.168.0.53
TNSR Public IP: 203.0.113.65
The NAT-T feature of TNSR will recognize there is a NAT device translation in the path (traversal) and float the VPN tunnel traffic to UDP port 4500. This ensures the external NAT devices does not block the IPsec (VPN) traffic.
TNSR NAT Inbound Forwarding of IKE and ESP Packets¶
By default, TNSR will block inbound traffic on the outside NAT inteface. To permit the IPsec traffic,
nat static mappings to forward the inbound IPsec traffic to TNSR.
nat static mapping udp local 192.168.0.53 500 external outside 500 nat static mapping udp local 192.168.0.53 4500 external outside 4500
These accessible UDP ports should be protected by an ACL, to includes source addresses in the rules when possible.
Configure IPsec Tunnel¶
Configure the IPsec tunnel on the remote office TNSR:
ipsec tunnel 108 local-address 192.168.0.53 remote-address 198.51.100.120 crypto config-type ike crypto ike version 2 lifetime 28800 proposal 1 encryption aes128 integrity sha1 group modp2048 exit identity local type address value 203.0.113.65 exit identity remote type address value 198.51.100.120 exit authentication local round 1 type psk psk AD78PPQMP00 exit exit authentication remote round 1 type psk psk AD78PPQMP00 exit exit child 1 lifetime 3600 proposal 1 encryption aes128gcm16 no integrity group modp2048 exit exit exit exit #
Configure IP Tunnel Address and MTU¶
Configure a static IP address on the IPsec tunnel, and set the
ip mtu to account for IPsec overhead:
interface ipip108 ip address 172.21.254.30/30 ip mtu 1400 enable exit #
To test, ping the other end of the IPsec tunnel with:
ping 172.21.254.29 source 172.21.254.30 count 5
Use this test any time you want to confirm if the IPsec Tunnel is load-bearing.
Configure IP Route to Corporate¶
Configure a static IP route to direct corporate traffic over the IPsec tunnel via the next-hop on the IPsec tunnel:
route ipv4 table ipv4-VRF:0 route 10.0.0.0/8 next-hop 0 via 172.21.254.29 exit exit #
configuration copy running startup