Tip

This is the documentation for the 24.06 version. Looking for the documentation of the latest version? Have a look here.

Rebooting and Shutting Down the Device

On rare occasions, such as for upgrades or hardware maintenance, administrators may need to reboot or shut down the device running TNSR.

Reboot

The reboot command, available in config mode within the TNSR CLI, initiates an operating system reboot. This is equivalent to using operating system commands such as reboot, shutdown -r, or systemctl reboot at a shell prompt.

Warning

Before performing this action, ensure the running configuration has been copied to the startup configuration or any changes to the current running configuration will be lost when TNSR starts back up.

See Saving the Configuration for details.

Warning

This action will cause an outage until the device fully reboots.

The general form of the reboot command is:

tnsr(config)# reboot (now|<minutes>) [force]
tnsr(config)# reboot cancel

The command has a few available options to control its behavior:

now:

Prompts for confirmation and then immediately initiates a reboot.

<minutes>:

Prompts for confirmation and then schedules a reboot for the given number of minutes in the future.

force:

Modifies either the now or <minutes> format commands to run without confirmation.

cancel:

Cancels a previously scheduled reboot.

Shut Down

The TNSR CLI does not have a command to shut down the device, but operating system commands can perform this action when necessary. On hardware which supports powering off, the shutdown process will also power off the device.

Warning

Before performing this action, ensure the running configuration has been copied to the startup configuration or any changes to the current running configuration will be lost when TNSR starts back up.

See Saving the Configuration for details.

Warning

This action will cause an outage until the device is powered back on and finishes booting.

From a shell, the shutdown process can be initiated by standard Linux shutdown commands which behave equivalently: systemctl poweroff, poweroff, halt, shutdown now, and others. These commands must be run using sudo or from a root user shell.

For example, shutting down using the poweroff command works as follows from within the TNSR CLI:

tnsr# host shell sudo poweroff

Alternately, on most devices a single short press of the ACPI power button will trigger a shutdown event.