Tip

This is the documentation for the 20.02 version. Looking for the documentation of the latest version? Have a look here.

Dynamic Routing Manager Configuration

Configuration of the dynamic routing manager itself is performed from within config-route-dynamic-manager mode, which is entered as follows:

tnsr(config)# route dynamic manager
tnsr(config-route-dynamic-manager)#

That mode offers logging and debugging commands, described next.

Logging

The dynamic routing manager daemon can send log messages to a file, via syslog, or both.

log file <filename> [<level>]

Instructs the dynamic routing manager daemon to send log messages to the specified file. The optional level parameter determines the verboseness of the logged data. See Log levels for details.

log syslog [<level>]

Instructs the dynamic routing manager daemon to send log messages to syslog. The optional level parameter determines the verboseness of the logged data. See Log levels for details.

Log levels

Log levels set the verboseness of the logging recorded by the dynamic routing manager. Each level includes messages from higher priority levels. The default level is debugging, which will log as much detail as possible.

Note

Even if the log level is set to debugging, actual debugging messages may not appear unless specific debug entries are set. See Debugging for details.

In order of verboseness, from low to high, the available level values are:

• emergencies

• alerts

• critical

• errors

• warnings

• notifications

• informational

• debugging

For example, if the log level is set to errors, then the logs will contain messages with a level of emergencies, alerts, critical, and errors, and will exclude the rest.

Debugging

The debug command controls which debugging messages will be logged by the dynamic routing manager. These include:

debug events

General events.

debug fpm

Forwarding Plane Manager events.

debug kernel

Kernel messages.

debug kernel msgdump [send|receive]

Raw netlink messages, optionally limited to send or receive messages.

debug nht

Next-Hop tracking events

debug packet [send|receive] [detailed]

Information about each packet seen by the dynamic routing manager. Optionally limited to send or receive packets. The detailed keyword will log additional information for each packet.

debug rib [detailed]

Routing Information Base events, optionally with more detailed information.

Note

Debugging messages will only appear in logs if the logs are set to include debugging messages. See Log levels for details.